ARP113SNECST Fluorescent Pendant Fixture
Page 1 of 1 8060178 rev 2
Safety Precautions
Read all safety precautions and installation instructions carefully
before installing or servicing this fixture. Failure to comply with
these instructions could result in potentially fatal electric shock
and/or property damage.
It is recommended that all wiring be performed by a qualified
electrician. This fixture must be wired in accordance with all national
and local electrical codes.
Do not handle any energized fixture or attempt to energize any
fixture with wet hands or while standing on a wet or damp surface or
in water.
Make sure that the power source conforms to the requirements of the
fixture. (See labels on fixture housing).
To reduce the risk of electrical shock, and to assure proper operation,
this fixture must be adequately grounded. To accomplish proper
grounding, there must be a separate ground wire (green) or bare metal
contact (metal conduit) between this fixture and the ground
connection of your main power supply panel. The green ground
screw location is clearly marked on the fixture housing.
This fixture is intended to be used for general indoor lighting in dry
locations only.
Assembly Instructions
1. Preparing for installation.
A. Disconnect electrical power before installing or servicing any part of this fixture.
B. Install #8-32 x 1” screws (2) and nuts (provided) into middle holes in gem bar (1) as
shown. Leave approximately 5/16” space between head of screw and gem bar.
2.
Wiring.
All wiring must take place inside junction box. Caution: Make sure power is off at
fuse or circuit breaker box. Check power wires for damage or scrapes. If power supply wires
are within three inches of ballast use wire suitable for at least 90C (194F). Note: Most
dwellings built before 1985 have supply wire rated to 60C. Consult a qualified electrician
before installing.
A. Securely attach green wire in canopy (3) to ground supply wire and to ground screw
located in gem bar.
B. Using wire connectors (provided), connect white supply wire to white fixture lead.
Connect black hot supply wire to black fixture lead. Do not mix wires. Pull on each wire
lead to make sure connections are secure. Make certain no bare wires are exposed outside
of wire connectors.
3.
Mounting.
A. Attach gem bar to junction box (not provided) with #8-32 x 1-1/2” screws (provided).
B. Press canopy over mounting screws (2) and fasten with thumbnuts (4).
4.
Lamp and Diffuser mounting.
A. Install lamp (7) into socket by inserting lamp pins into lamp holder and press until lamp
snaps in place.
B. Lift metal cup (5) until setscrews (6) are exposed.
C. Insert diffuser (8) over lamp (set screws may need to be screwed inwards to clear) and
align holes in diffuser with setscrews. Adjust setscrews so that heads are flush with outer
surface of glass. Ensure diffuser is held securely.
D. Replace metal cup over diffuser.
5.
Power to the fixture can now be restored.
Limited Factory Warranty
American Fluorescent Corporation hereby warranty that this fixture is free from defects in materials and workmanship when
installed and used under normal operating conditions for a period of 2 years from date of purchase. This warranty covers all
component parts and extends only to replacement of defective fixture or components; it does not cover failure due to
improper installation, misuse, mishandling or damage incurred in transit.
(2 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels