Afx TAS0613113QMVPCLA Manuel d'utilisateur télécharger pdf

TAS Series Fluorescent Wall Sconce

Models 113, 118, 213, 218

Page 1 of 1 8060487 rev.1

Safety Precautions

Read all safety precautions and installation instructions carefully

before installing or servicing this fixture. Failure to comply with

these instructions could result in potentially fatal electric shock

and/or property damage.

It is recommended that a qualified electrician perform all wiring. This

fixture must be wired in accordance with all national and local

electrical codes.

Do not handle any energized fixture or attempt to energize any

fixture with wet hands or while standing on a wet or damp surface or

in water.

This fixture is designed for use in a 110-120VAC, 60Hz fused circuit.

Do not use on a dimming circuit.

To reduce the risk of electrical shock, and to assure proper operation,

this fixture must be adequately grounded. To accomplish proper

grounding, there must be a separate ground wire (green) or bare metal

contact (metal conduit) between this fixture and the ground

connection of your main power supply panel. The green ground

screw location is clearly marked on the fixture housing.

This fixture is intended for general indoor lighting in dry or damp

locations only.

Assembly Instructions

1. Preparing for installation-

A. Disconnect electrical power before installing

or servicing any part of this fixture.

B. Remove shade assembly (1) arm/backpan

assembly (6) from carton. Separate contents of

hardware bag.

Wiring- all wiring must take place inside

junction box.

Caution: Make sure power is off at fuse or circuit

breaker box. Check power wires for damage or scrapes.

If power supply wires are within three inches of ballast

use wire suitable for at least 90C (194F). Note: Most

dwellings built before 1985 have supply wire rated to

60C. Consult a qualified electrician before installing.

A. Attach gem bar (7) to junction box (not

provided) with two of the 1 ¼” screws (8)

provided.

B. Securely attach fixture green (or green and

yellow) wire to ground wire from junction box.

C. Using wire connectors (9), connect white

supply wire to white ballast lead. Connect

black hot supply wire to black ballast lead. Do not mix wires. Tuck all connections neatly into junction box.

3. Mounting-

A. Attach mounting plate (11) to wall. Measure 7” down from center of gembar and over ½” left and right. Mark holes and

install arm mount plate with #8 wood screws (provided) and anchors if needed (provided).

B. Hook the plate on the arm assembly to the bracket and insert the threaded nipple with the thumbnut (3) attached. Tighten

until secure.

C. Install wood screw (2) into anti-rotational hole (2A) in back pan to prevent the fixture from rotating.

Lamp –

A. Install appropriate 13/18 watt 4-pin quad lamp(s)(5) per label on face of back pan. Insert lamp pins into lamp holder (5A) and

press downwards until lamp snaps in place.

Shade-

A. To install the shade assembly (1), align the two holes in the diffuser with the two holes on the top of the back pan and secure

with short screws (6).

6. Restore power at fuse or circuit breaker box.

Limited Factory Warranty

American Fluorescent Corporation hereby warranty that this fixture is free from defects in materials and workmanship when installed and used under

normal operating conditions for a period of 2 years from date of purchase. This warranty covers all component parts and extends only to replacement

of defective fixture or components; it does not cover failure due to improper installation, misuse, mishandling or damage incurred in transit.

Résumé du contenu

Page 1 - Safety Precautions

TAS Series Fluorescent Wall Sconce Models 113, 118, 213, 218

Modèles reliés TAS1313213QMVPCLA

Commentaires sur ces manuels

Pas de commentaire

Afx TAS0613113QMVPCLA Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Éclairage Afx TAS0613113QMVPCLA. AFX TAS0613113QMVPCLA User Manual Manuel d'utilisatio

Résumé du contenu

Modèles reliés TAS1313213QMVPCLA

Commentaires sur ces manuels

Produits connexes et manuels pour Éclairage Afx TAS0613113QMVPCLA